Burgundy
Off the grid

Off the grid, Nov 1

A refrigerator that runs on a flame, a battery brought back cell by cell, a 1930s wind charger: tonight's builders make old and homemade gear work again.

Burgundy
3 min read ·

Tonight's issue opens with a refrigerator that cools without a plug. Ben Krasnow built a clear, 3D-printed Einstein-Szilard absorption refrigerator that runs on an alcohol burner and reached five degrees Celsius below the surrounding air, Hackaday's Aaron Beckendorf reported on 31 October 2026. The cycle is driven only by heat. Boil a strong solution of ammonia in water, the pressure above a liquid refrigerant falls, and that refrigerant evaporates and pulls heat in, until both gases meet water again and the cycle restarts. Krasnow chose perfluoropentane as the refrigerant because it does not burn, which matters next to an open flame, and a copper block carries the burner's heat into the boiler.

Hackaday notes that absorption refrigerators are not very efficient but "have earned a persistent place in camper vans and industrial plants" because they can run on waste heat alone. That trade, low efficiency for independence from the grid, runs through the rest of the night.

Much of the issue is about bringing dead gear back. A 24-volt, 100 amp-hour lithium battery had sat two years with no charge and would not respond to the usual revival tricks. It came back after its new owner cut open the sealed case and used a cell balancer to bring each of the eight cells to about 10 percent. "After doing that to all the cells the BMS woke up and the battery acepted a charge," forum member speakerfritz wrote on 31 October. Another builder, sandxssun, bought a complete 1930s 32-volt Wincharger in Colorado to charge a backup battery bank: "it's a beast and probably not very efficient," they wrote, asking whether anyone has set one up.

Old machine tools got the same treatment. One member stripped a boring head full of tiny ball bearings, warned against by an older post, and found it "not really that bad if you take it apart in a plastic tub." A 1947 Nichols mill had petrified grease in its oil passages. A Logan 922 lathe idle for eight years needs a fabricated motor support leg and a manual.

Around these rebuilds, builders worked through winter power. A Saskatchewan member paired two 12-volt batteries, a 3,000-watt inverter and a 2,000-watt generator to keep a furnace running through outages. An Oklahoma member planned a hand-truck battery for storms. Others asked finer questions: whether an MPPT controller can be skipped when panel voltage never exceeds the battery's charge voltage, and how to wire spare panels on a Victron controller.

Two threads asked whether gear can be fixed at all. One member called the Vatrer 560 amp-hour battery serviceable, with cells that can be repaired or replaced, while another asked Signature Solar directly what inverter repair looks like once the warranty ends. A third disputed that solar generators can only be grown with the maker's own parts, laying out a staged path from a plug-and-play station to external batteries.

One thread stepped back to the water itself. A post on PFAS quoted a definition of the "forever chemicals" now reported in air and rain, asking collectors of rainwater not how much they can store but what is in it.

Sources

  1. 3D Printed Einstein-Szilard Refrigerator Cools with Fire · Hackaday
  2. adding internal heating capibility to 24V 100AH lithium battery · DIY Solar Forum
  3. 1930s 32V Wincharger · DIY Solar Forum
  4. 'precision Universal Tool' Boring Head Problem · The Hobby-Machinist
  5. PFAS · DIY Solar Forum
  6. Hey Will Vatrer 560AH Now UL1973 Tested · DIY Solar Forum

More from Burgundy