Off the grid, Nov 18
Salvaged panels, orphaned batteries and a mower on lithium: tonight is about coaxing more out of the power gear already lying around.
Tonight's issue circles one question. How do you get more out of the power gear you already own when it is secondhand, mislabeled, or left stranded by a company that no longer exists? The answers come mostly from builders writing up what they tried, plus a couple of lessons in reading the hardware around you.
The clearest win is a two-axis solar tracker from Greenhill Forge, written up by Maya Posch at Hackaday. The design swaps the costly slewing bearing at its heart for a trailer axle hub. A geared motor and chain turn the azimuth axis, and a worm-gear linear motor on the second axis should hold position during wind or a power loss. A quad photoresistor follows the sun, and limit switches stop the mechanism before it damages itself. Tested over two days against an identical fixed panel, the tracker made roughly 30 to 50 percent more energy, Hackaday reports, though the power the motors draw has to come off that gain. "Setting up a photovoltaic panel is simple, but you lose a lot of potential power if you merely bolt said panel into place," Posch writes.
Practical Engineering turns the same eye on the grid itself, reading a transmission line's voltage off its insulators. Air is the insulator here, and it arcs over at about 20 to 30 kilovolts per centimeter, so the tower's geometry comes down to distance: strings about two meters long suggest 138 to 230 kV, rods of 15 feet or more suggest 500 kV and up, and for old ceramic discs the count times 15 roughly gives the kilovolts. "They're out in the open for anyone to have a look," the piece notes of the lines.
The DIY Solar Forum supplies the hard-won basics. One builder blew an inverter's power supply with a miswired connection: "My bad because I did not take the time to add my switch inline first." Another found the cables shipped with a 5 kW package carried no gauge or rating at all. And owners of GivEnergy batteries are improvising after the firm's collapse. One writes plainly, "I know GivEnergy have gone out of business," while another proposes swapping the battery management system to save two boxed 8.2 kWh units.
Reuse runs through the rest. A Ryobi RM480e owner nursed its lead-acid batteries for five years, until "mowing sessions between charges had reduced to ½ hour," then switched to four cheap 100Ah LiFePO4 cells. A Texas array built mostly from used panels carries a 15.7 kW rating but has never topped 10,015 watts, and its owner wants to know whether that is normal before hunting faults.
Beyond power, the night teaches cold-weather craft. Scientific American's illustrated guide to an air-source heat pump, Hobby Farms on how frost damages plants and whether to fit a beehive entrance reducer, a machinist 3D-printing a 36-hole index plate. And far overhead, Voyager 1 reaches one light-day from Earth at 5:16 a.m. EST, where "a command radioed from home will need 24 hours to arrive, and a reply another 24 to come back."
Sources
- Making an Affordable Two-Axis Solar Tracker · Hackaday
- Why Are There So Many Different Transmission Towers? · Practical Engineering
- Power supply. · DIY Solar Forum
- Eco-worthy 5kw off grid AIO inverter unlabeled cables · DIY Solar Forum
- GivEnergy 5.2kWh Gen 1 Battery Firmware · DIY Solar Forum
- Givenergy Gen 2 Radical Hack! Change BMS - Save the system? · DIY Solar Forum
- Ryobi RM480e upgrading and documentation · DIY Solar Forum
- 15.7kW of Solar Panels, 5 Victron Solar Charge Controllers, But Only Seeing 8.5-10kW Peak. Is This Normal for Used Panels? · DIY Solar Forum
- How do heat pumps work? An illustrated guide · Adafruit Blog
- Beehive Entrance Reducer: Should You Use One in Winter? · Hobby Farms
- Voyager 1 reaches 1 light-day from Earth · Astronomy Magazine